Long-Range Radio
The built-in UHF radio takes corrections from your own base. FJD quotes up to 11 km from a 2 W base in good conditions.
FJD Trion V1t Base & Rover RTK Kit
UHF Base, V1t Rover & E600 Controller
- Your own RTK base: no mobile coverage needed
- UHF base: about 5 km typical, up to 11 km (FJD)
- V1t rover with tilt compensation to 60°
- 8 mm + 1 ppm RTK accuracy (FJD rating)
- E600 controller runs both, with Trion Survey ready to use
- No correction subscription to pay
Some accessories shown are optional extras. See what's included
$6,950.00inc GST
Available to order
This bundle includes
Complete Your Kit
- Free delivery Australia-wide. Usually delivered in 2–3 weeks.
- Talk to a GNSS specialist. Call 1800 769 858 or .
Overview
Everything for base-and-rover RTK in one order: the FJD Trion V1t base station kit with a 2 W UHF radio, and the V1t rover kit with tilt compensation and FJD's E600 controller with Trion Survey ready to use. The base sends corrections to the rover by radio, so you get centimetre RTK with no mobile coverage or correction subscription.
This kit puts the V1t base station kit and the V1t rover kit together. It’s the lowest-cost way into your own base-and-rover RTK system, for farms, rural blocks and remote jobs.
How It Works
Set the base up on a tripod over a fixed point and start it from the E600 controller. It transmits corrections over its 2 W UHF radio, and the rover uses them wherever it can hear the base: FJD rates the link at about 5 km in normal conditions (3–8 km depending on terrain and interference) and up to 11 km at 2 W in good, open country. Where there is mobile coverage, the rover can also take network (NTRIP) corrections through the E600’s 4G. A UHF base transmitting in the 400 MHz band needs an ACMA apparatus licence.
Survey Performance
RTK accuracy is 8 mm + 1 ppm horizontal and 15 mm + 1 ppm vertical. The rover’s IMU compensates for pole tilt: FJD quotes 2.5 cm at 30°, up to 60°. Both receivers are IP67 and drop-tested to 1.5 m.
What You’ll Add
A tripod for the base and a survey pole for the rover: add our HDF94 heavy-duty tripod and the FJD carbon fibre pole below. The base screws onto any 5/8-inch survey thread; for setting up exactly over a survey mark, use a tribrach.
Videos
FJD Trion V1 Series RTK rover
Key Features
Tilt Survey with a Built-in IMU
The IMU corrects for pole tilt, so you don't need to plumb the pole. FJD quotes 2.5 cm at 30°, up to 60°.
E600 Controller Included
FJD's rugged Android controller with a keypad and 4G, with Trion Survey ready to use. It also supplies network corrections to the V1t.
Also in this kit: FJD Trion V1t GNSS Base Station Kit UHF Radio for Base-and-Rover RTK
Your Own Base, No Coverage Needed
The base sends RTK corrections to your rover over UHF radio, so you can work where there's no mobile signal and pay no correction subscription.
Long-Range UHF Radio
FJD rates the 2 W radio at about 5 km in normal conditions and up to 11 km in good, open country. Antenna height makes the biggest difference.
Power for Long Days
Up to 10 hours at 1 W from the internal battery, or run it from an external 9–32 V supply.
What's Included
- FJD Trion V1t GNSS receiver (2 W radio)
- FJD E600 field controller with Trion Survey
- E600 pole bracket and wrist strap
- UHF radio antenna
- USB-C charging cables for the receiver and controller
- Carry case, user manual and warranty card
- Survey pole not included (add one below)
Plus the FJD Trion V1t GNSS Base Station Kit UHF Radio for Base-and-Rover RTK
- FJD Trion V1t GNSS receiver (2 W radio)
- UHF radio antenna and antenna connector
- Base extension rod and tribrach plate
- USB-C charging cable
- Carry case, user manual and warranty card
- Tripod not included (add the HDF94 below)
Full Specifications
| RTK Accuracy | Horizontal 8 mm + 1 ppm; vertical 15 mm + 1 ppm (RMS) |
|---|---|
| Tilt Compensation | 2.5 cm (horizontal) at 30°; up to 60° |
| GNSS | 1408 channels; GPS, BeiDou, GLONASS, Galileo, QZSS, NavIC, SBAS |
| RTK Initialisation | Under 5 s (baseline under 10 km); over 99.9% reliability |
| Built-in UHF Radio | 2 W rover radio; 410–470 / 902–928 MHz |
| Radio Protocols | LoRa, TRIMTALK, TRIMMARK III, T450S, TRANSEOT, Satel 3AS 4FSK |
| Radio Range | Up to 11 km from a 2 W base, good conditions (FJD claim) |
| 4G | None: network corrections through the E600 controller's 4G |
| Can Work as a Base | Yes |
|---|---|
| Battery | 6,500 mAh; up to 15 h as a rover; 30 W USB-C PD fast charge (Australian wall charger not included) |
| External Power | 9–32 V DC |
| Toughness | IP67; 1.5 m drop; -30 °C to +60 °C |
| Size and Weight | 162 × 86 mm; 1,070 g |
| Memory | 32 GB |
| Controller | FJD E600 (included), with Trion Survey ready to use |
FJD Trion V1t GNSS Base Station Kit UHF Radio for Base-and-Rover RTK
| RTK Accuracy | Horizontal 8 mm + 1 ppm; vertical 15 mm + 1 ppm (RMS) |
|---|---|
| GNSS | 1408 channels; GPS, BeiDou, GLONASS, Galileo, QZSS, NavIC, SBAS |
| Internal UHF Radio | 1 or 2 W; 410–470 / 902–928 MHz |
| Radio Range | About 5 km typical (3–8 km); up to 11 km in good conditions |
| Radio Protocols | LoRa, TRIMTALK, TRIMMARK III, T450S, TRANSEOT, Satel 3AS 4FSK |
| Correction Formats | Output RTCM 3.x; input CMR, RTCM 2.x, RTCM 3.x |
| Update Rate | 1, 2 or 5 Hz |
| Battery | 6,500 mAh; up to 10 h as a base at 1 W; 30 W USB-C PD fast charge (Australian wall charger not included) |
|---|---|
| External Power | 9–32 V DC (aviation plug) |
| Toughness | IP67; 1.5 m drop; -30 °C to +60 °C |
| Size and Weight | 162 × 86 mm; 1,070 g |
| Memory | 32 GB |
| Mount | 5/8-inch survey thread; extension rod and tribrach plate included |
| Setup | From your FJD rover's E600 controller in Trion Survey |
Reviews
Only verified customers can leave a review
No written reviews yet.
